InstallFrontier · SummitAbout 12 minutes7 steps

Installing the ankle stabilization strap

The ankle stabilization strap adds side support for uneven ground. It fits Frontier and Summit braces.

Video cover photo · set in Admin

Step by step

Photo: unpack the strap

STEP 1

Unpack the strap

Lay out the strap, the two anchors and the screws.

Photo: find the anchor points

STEP 2

Find the anchor points

The anchors fit the two threaded holes on the inside of the frame, just above the footplate.

Photo: attach the lower end

STEP 3

Attach the lower end

Screw the lower anchor in place and clip the strap on.

Photo: attach the upper end

STEP 4

Attach the upper end

Repeat with the upper anchor.

Photo: adjust tension

STEP 5

Adjust tension

Put the brace on and tighten the strap until your ankle feels supported but not squeezed.

Photo: walk test

STEP 6

Walk test

Walk on a soft surface and then on a hard one.

Photo: final check

STEP 7

Final check

Make sure both anchors are tight and the strap lies flat.